Investigation of a contact resonance atomic force microscopy scan speed phenomenon

Loading...
Thumbnail Image

Authors

Glover, Christopher C.

Issue Date

2018

Type

Thesis

Language

Keywords

Atomic Force Microscopy , Contact Resonance , Hydrodynamic Lubrication , Scan Speed Dependence , Thin Film

Research Projects

Organizational Units

Journal Issue

Alternative Title

Abstract

There are many unexplained phenomena that have been observed via atomic force microscopy (AFM) experiments. Understanding the cause of these phenomena is important to perform more accurate quantitative imaging using contact-resonance AFM and other contact-mode AFM techniques at higher scan speeds. This thesis presents evidence to confirm the existence of a scan speed dependent contact-mode AFM phenomenon and applies a squeeze film hydrodynamic lubrication model to explain it. Contact-resonance spectroscopy is used to investigate the phenomenon in which, above a critical scan speed, there is a monotonic decrease in the measured contact-resonance frequency with increasing scan speed. The observed phenomenon was replicated on a mica sample in a randomized set of AFM experiments performed at the National Institute for Standards and Technology (NIST). A literature review revealed that there is a thin water film that exists on mica under certain relative humidity (RH) conditions that has dynamic properties. The squeeze film hydrodynamic lubrication model predicts the general trend observed in the experimental data. However, there exists a higher order model that can be used to investigate the scan speed phenomenon more completely.

Description

Citation

Publisher

License

Journal

Volume

Issue

PubMed ID

DOI

ISSN

EISSN